![]() Use this command link the file from available to enabled. That monit configuration file is in the conf-available and not the conf-enabled. This probably is not used but in case Z-Way does start to spawn child processes if it gets out of hand, it will eventually get restarted. The eighth line would be where a bunch of children processes have been spawned. So this setting should fit what your system has and where your z-way process currently uses for memory usage. My Pi's have 8GB of RAM, so that amount of memory use could be achieved. If you have a Pi with 512MB of RAM, that would not be a valid configuration setting since it could never be reached. 800.0 MB is a lot of memory and Z-Way doesn't use anywhere close to that which is why I also used that value, it would be well outside the norm and clearly an indication of something gone awry. Updating all packages except for the Raspberry Pi bootloader by entering this at the command prompt: sudo apt-mark hold raspberrypi-bootloader sudo apt-get update sudo apt-get upgrade. Open advanced options by clicking on the button with. Find the OctoPi image under Choose OS, by selecting Other Specific Purpose OS > 3D printing > OctoPi and then the stable version. If you haven’t already, download and install Raspberry Pi Imager on your computer. Sudo apt-get install monit To check the version use this command. Read and follow these instructions precisely. ![]() You can set the CPU usage to whatever you like or feel is appropriate for your setup. When I first created my current Raspberry Pi 4 NTP server, I created a monitoring. The sixth line is if the CPU usage is > 80 for five cycles (my cycle is 15 seconds) then restart the process. This means there is obviously an issue that require intervention on your part. The fifth line is if it restarts and then has to keep restarting as it keeps failing, then timeout. The fourth line is checking reachability on port 8083 using http and if a connection cannot be established it is viewed as failed and to restart the process. ![]() The start and stop commands are telling it how to start and stop the process. ![]() The first line is telling it of the process and where the pid file is. If loadavg(5min) greater than 3 for 8 cycles then stop If totalmem > 800.0 MB for 5 cycles then restart If failed port 8083 protocol http then restart Stop program "/etc/init.d/z-way-server stop" Start program "/etc/init.d/z-way-server start" Code: Select all check process z-way-server with pidfile /var/run/z-way-server.pid ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |